【Mrefilter】The important points of replacing oil filter

 Oil filter is used to remove the metal particle and other impurities, so that it can avoid coming to the lubrication system and cause the wearing.

After the oil filter being used for a while, the element will accumulated a lot of dust and metal particles and cause the blockage of the filter, which prevent the normal working. At this time, it should replace the filter element

Modern car is widely used in overflow oil filter. This kind of filter has good filter efficiency, low oil flow resistance and will be used conveniently. This replacement is very easy.

1)The preparation of replacing filter. First it needs to mount the car high, which can make releasing the oil easy. Put the oil pan to the plug screw of the engine, take off the plug screw and release the oil

2)Dismounting the filter element. When the old oil in the oil pan plug screw hole finished releasing, it needs to use filter wrench to dismantle the filter element. When manage, take care and not make the oil flow everywhere, so that it can avoid making the engine and management environment dirty. Prepare the same element, paint a layer of oil on the o-ring element and use hand to screw the element tight.

Do not use filter wrench to screw it tight, so that it can avoid damaging the oring and cause oil leakage

Start the engine, in the idling condition, check whether there is any leakage, if there is leakage, it should take down the oil seal and exclude the oil leakage
  
The important points of replacing oil filter
1.Before installing the over flow oil filter and bypass type oil filter, it should check whether there is turn pressure traces and check whether the sealing washer is damaged

2.Adding the regulated brand oil to the filter, soaking the element and make it in working state, paint small amount of oil or butter on the filter rubber mat and then screw it to the base of oil filter

3. After placing the added oil filter for 5 minutes, add oil again and after repeating many time until the all the air be discharged and the filter is full of oil